Accidents happen, which sometimes means your pillow has blood spots on it. But don’t worry. Getting blood spots out of your pillow is easier than you think.
In this piece, we’ll talk about some of the best ways to get blood out of a pillow, so you can rest easy knowing it’s clean and fresh.
How to Remove Blood from a Pillow- Remedies
The following is a list of the several approaches that can be taken to remove blood from a pillow.
You choose to select one of the two solutions, depending on whether you already have the necessary components in your home or whether you would instead purchase the appropriate stain remover from a store in the area.
It is essential to keep in mind that the longer the bloodstain remains on your pillow, the more difficult it will be to remove. Therefore, if the pillow has been stained with blood for some time, we suggest you repeat the process.
Method 1: Baking Soda
You will need some baking soda, cold water, and a piece of clean fabric to apply the mixture to use this procedure.
- Take the cushion out of the bag. The pillowcase can be cleaned the same way, but take care of the fabric by soaking it in cold water and then tossing it in the washer.
Cleaning the pillow is the most critical step.
- A 1:2 mixture of baking soda and cold water is the best method. When using baking soda, use two cups of water for every one cup of baking soda. Make sure everything is mixed thoroughly.
- Apply this combination to the stains on your pillow using a clean cloth. To avoid spreading and deepening the stains, be careful not to rub the affected region too forcefully.
- Cold water should be used to rinse the baking soda mixture from the pillow after 30 minutes. Pouring water on the pillow may cause it to absorb moisture, so run it under cold water from the faucet if you can.
- Leave it for around 15 minutes using another clean rag to remove any remaining soap residue from the cushion. This will absorb the water.
- Allow it to air dry if the pillow is constructed of soft materials prone to wrinkling.
Method 2: Using Gonzo Stain Remover
An excellent Gonzo stain remover, detergent, and a brush are required. The time required is at least three hours.
The following are the steps:
- Make a bloodstain on your bare-faced pillow.
- Using protective gloves, apply a suitable amount of Gonzo stain remover to the bloodstain area.
- Allow the product to sink into the surface of your pillow for at least ten minutes before proceeding with the next step.
- Once the product has been allowed to work its way into the bloodstain, apply a water and detergent solution to the pillow’s surface.
- Scrub the bloodstain on the cushion with a brush in a circular motion until the stain is removed. It may take some time, but it’s time well spent.
- Clean the pillow by rinsing it in some warm water.
- Allow the cushion to air dry or dry it using a dryer explicitly designed for washing.
Method 3: Hydrogen Peroxide
With this approach to cleaning your cushion, you’ll need a vacuum cleaner to obtain the most significant results. The dye mixture can be scooped up using a brush. Hydrogen peroxide (3%), cornstarch, salt, and a clean cloth are all you’ll need.
- A mixture of two tablespoons of salt, four tablespoons of cornstarch, and four tablespoons of hydrogen peroxide. When you’re finished, you’ll have a paste. This paste should be applied to the entire stain.
- Let the paste dry thoroughly before doing any more work. This could take anywhere from 15 minutes to an hour, depending on the size and intensity of the stain.
- Because of the paste, the pillow will have absorbed all the blood. Remove the dry paste from the cushion with a tiny brush.
- Dab the pillow once the paste has been cleaned off using a clean towel dipped in cold water. This procedure will remove the discoloration and any excess paste from the pillow.
- Gently vacuum the pillow’s surface if you can access a vacuum cleaner.
- Do not use a vacuum cleaner to remove the paste from your pillows. Instead, you can run the pillow in cold water and use an old toothbrush or cloth to wipe away the residue.
- If the stain has not been removed, repeat the methods outlined above.
- A fan indoors will help dry the pillow if it isn’t scorched after an hour in the sun. Don’t leave your pillow in direct sunlight for long periods, which can cause discoloration. Alternatively, you can use a dryer for low heat and tumble.
Method 4: Use an Ammonia Cleaning Product
Needed items include a cleaning product including ammonia, hydrogen peroxide, salt, a clean cloth, and cold water. The time commitment is at least three hours.
Reminder: This item has a pungent stench, so use caution when handling it. Children should be kept out of the way throughout this procedure. If you have a moderately bloodstained pillow, you probably don’t need this option reserved for extreme cases.
The following are the steps:
- Get the pillow ready to be stained with blood.
- Use a cloth that has been dampened in ice water to dab the soiled area to make it more absorbent.
- Once the top of the pillow has been moistened, sprinkle salt evenly over the whole surface of the cushion.
- Allow the pillow to dry completely before using it again after applying the salt.
- Using hydrogen peroxide at a concentration of 3 percent, spread the residual stain until it begins to bubble.
- Using a clean piece of fabric, dab the stain in the affected area until the bubbling stops.
- Following the ratio of one tablespoon of ammonia to one cup of cold water, the next step is to blend the two ingredients.
- Dab some of the concoction onto the surface of the bloodstain on the pillow.
- To remove any residues of ammonia, clean the area with cold water.
- Allow the cushion to air dry or dry it using a dryer explicitly designed for washing.
Tip:
It is a good idea to make a plan to decrease the amount of blood that gets on the pillows.
If you anticipate it will occur, you might consider using an old pillowcase or covering your pillow with a towel. Alternate clothing is much easier to launder than a cushion itself. Therefore that’s what you should do.
Method 5: Stain Remover
Baking soda and hydrogen peroxide to clean a pillow may be quick and effective. However, stain removers may be more effective in some situations. You’ll need a good stain remover, a scrub brush, and some mild dishwashing liquid to use this technique.
- Make sure you use the stain remover on the stained area. Because many of these stain removers include extremely potent cleaning ingredients, using them while wearing gloves is essential.
- It will take some time for the stain remover to penetrate the pillow. Allow at least 15 minutes for the stain remover to work its magic.
- Add some dishwashing liquid to some water. Use this foaming water to wash away the remover and the stain with a brush once it has been foamed. Make sure you brush your pillow in little, gentle strokes to avoid damaging it.
- Use warm water with stain removers if you want the best results. Be careful not to overheat the water because it could damage the pillow’s content.
- If the stain can still be seen, proceed as directed in the previous steps.
- Allow the cushion to air dry or dry in a dryer set to a low heat setting and a low tumble setting.
Frequently Asked Questions
Is toothpaste capable of removing blood stains?
Apply a small amount of toothpaste to the bloodstain and wait for it to dry. Use cold water to remove the toothpaste when it has dried. Then use a washcloth, soap on the material, and a cold-water rinse to remove any soap residue.
Is vinegar capable of removing blood stains?
While blood stain removal is quite simple, the problem is trying to remove it as quickly as possible before it dries. Pour vinegar on the spot and let it soak for 5-10 minutes while wiping it with a damp cloth before it turns to dried blood.
Is baking soda capable of removing blood stains?
Apply a paste of baking soda to a bloodstain that has been moistened. Allow it to rest for at least an hour. It can aid in stain removal from clothing. B baking soda is an effective stain remover because of its ability to both whiten and remove color or dye.
What is the best way to get blood out of a pillow?
Cold water dissolves blood. Therefore the first step in eliminating it is to soak and remove it. Remember that cooking the blood stain with hot water will just set it in place. Remove the blood stain by dabbing it with a cool water-soaked cloth.
How do you clean a mattress of old bloodstains?
Mix 1/4 cup hydrogen peroxide with 1 tbsp to remove dried bloodstains. Each liquid dish detergent and table salt. Allow the stain to dry before scraping the residue off with a scrubbing brush.
How do you clean pillowcases that have been stained?
Use cold water to remove the stain from the reverse side of the pillowcase. Blot the spot with a clean, dry cloth, then flip the pillowcase. Dish soap; a dot on the stain should do the trick. Using your fingers, apply soap to the stained area.
How can you get period stains out of your clothes?
5 Methods for Getting Blood Out of Fabric
- Use cold water to wash lightweight clothes.
- Invest in blood-removal products to make your laundry more hygienic.
- Use a saline solution or salt to remove stains.
- To remove the discoloration, use hydrogen peroxide or lemon juice.
- Aspirin or baking soda can also be used to remove the stain.
Bottom Line
In homes with pets, children, or adults prone to nosebleeds, bloodstains on pillows are regular. Despite their frightening appearance, bloodstains on pillows can be cleaned with a towel and cold water.
Unfortunately, dried blood stains or stains that have settled into your pillow pose a greater risk. We sincerely hope that this guide on removing blood from a pillow has been helpful to you.
There are extensive instructions on removing blood from a pillow, and the second step will work even if the first one doesn’t. If necessary, you can repeat the processes or even combine the methods, so keep that in mind. I sincerely hope our instructions on removing blood from a pillow were helpful.
